#712 HO Scale Split Shank 3/4 size Old Time Plastic Couplers - Rust
This 3/4 size coupler has an extended Trip Pin mounted on a narrow gauge coupler to use with light duty old time equipment. The #711 & #712 works with Kadee's® full size HO-Scale Couplers. With this smaller coupler, gathering will not be as great nor can they bear the same loads as Kadee's® HO Couplers. They should easily handle loads common to the pre-1900 era.
This industry leading coupler features a plastic coupler and coil centering spring and comes complete with a insulated draft gearbox and lid. The #712 Magne-Matic® Split Shank Couplers may be body mounted on any flat surface; HO-Scale locomotives or rolling stock.
(The #702 Coupler Assembly Fixture can be used to ease assembly)
It is not recommended to use a metal coupler directly on a metal surface or in a metal draft gearbox to avoid possible electrical crossover and shorting that may cause damage.
Two pair per package
Made in the U.S.A.
0-48 or 0-80 screws are the most commonly used screws.
Screw length will very depending on the mounting situation.
- (2) Pair Unassembled Split Shank Couplers
- (2) Pair Unassembled Gearboxes & Lids
- (5) Each #712 Trip Pins
- (6) Each #636 Centering Springs
- (4) Each #402 Self Tapping Screws 0-48 x 1/4"
#712 Split Shank Coupler Features:
|| - Plastic
|| - (3/16")
|| - Centerset
#712 Gearbox Features:
|| - Insulated Plastic
|| - 27/64"L x 15/64"W x 1/8"H
|| - 11/32"
|| - 25/64"
|Trip Pin Height
|| - 1/32"
|| - 0-48 Screw. (Screw length will vary) no less then 1/4" length.
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
CHOKING HAZARD - Small Parts - Not for children under 14 years.
Kadee Quality Products Co. products are not toys and are not intended for children under 14 years old.